Sears 247.37035 - Manual (Page 7)

ASSEMBLY
REMOVING UNIT FROM CARTON
• Remove staples, break glue on top flaps, or cut
tape at carton end and peel along top flap to
open carton.
• Remove loose parts if included with unit (i.e.,
owner's manual, etc.). See Figure 1.
1. Remove manual & loose parts
2. Roll unit out
Figure 1
• Cut along dotted lines and lay carton down flat.
• Remove packing material.
• Roll or slide unit out of carton. Check carton
thoroughly for loose parts. See Figure 1.
Note: Make sure not to crimp the cables while
removing the loose parts or the entire unit from the
carton.
IMPORTANT: This unit is shipped without gasoline
or oii in the engine. Be certain to service engine with
gasoline and oil before operating your mower.
NOTE: Reference to right or left hand side of the
mower and/or front or behind the mower is observed
from the operating position.
LOOSE PARTS
a. Side Discharge Chute
b. Owner’s Manual
c. A Bottle of Engine Oil
TOOLS REQUIRED
a. Pair of Pliers
b. Funnel
DISCONNECTING SPARK PLUG
• Before setting up your lawn mower, disconnect
the spark plug wire from the spark plug, and
ground it against the engine. See Figure 2.
• Attach rubber boot to a bolt on the engine to
ground.
ASSEMBLING HANDLE
• Raise the lower handle in the direction shown in
Figure 3A. The lower handle should snap into
place.
B
Figure 3