Sears 247.37035 - Manual (Page 18)

stabilizer to allow the stabilizer to reach the
carburetor.
• Do not drain the gas tank and carburetor if
using fuel stabilizer. Drain all the oil from the
crankcase (This should be done after the
engine has been operated and is still warm)
and refill the crankcase with fresh oil.
Oil cylinder bore
After you have drained the fuel tank, protect the
inside of the engine as follows:
• Remove spark plug, pour approximately one
ounce (30 ml) of engine oil into spark plug hole,
and crank slowly to distribute oil.
WARNING: Avoid spray from spark plug
hole when cranking the engine slowly. A
• Replace spark plug; do not connect spark plug wire.
Change oil
• Change oil if it has not been changed in the last
three months. For instructions on how to
change oil refer to the Maintenance section of
this manual.
Clean engine
• Clean engine and remove any grass clippings,
dirt, or chaff from the exterior of the engine.
• Remove any dirt or debris from cooling fins, air
intake screen, levers, and linkage.
OTHER
• Do not store gasoline from one season to
another.
• Replace your gasoline can if it starts to rust.
Rust and/or dirt in the gasoline will cause
problems. Store unit in a clean, dry area. Do not
store next to corrosive materials, such as
fertilizer.
NOTE: If storing in an unventiiated or metal storage
shed, be certain to rustproof the equipment by coating
with a light oil or silicone.
18