Sears 274.4394859 - Manual (Page 31)

Reference
Trouble Checks
Trouble
Checks and Adjustments
Remote
Remote lockup Remove batteries and hold down one or more buttons for several seconds
to drain the microprocessor inside the remote and reset it. Re-install the
batteries and try remote again.
Buttons don't work when you
press them Press TV to set the remote to control the TV. See buttons on page 6-7.
Works part or none of the
time
Clear the path between the remote and TV of any objects.
Aim the remote at the component you are trying to control.
Press TV so remote will control TV.
Make sure batteries in the remote are not dead.
See if batteries are placed in remote correctly. See batteries, page 2.
Can't select certain channel
Sound
Press number buttons. Channel may not be in memory. See autoprogram
on page 20.
Make sure TV/VCR switch on VCR is in the TV position.
For numbers over 100, press and hold 1 until 1- appears, then press the
other two numbers.
Set Cable/Air feature to Cable for channels higher than 69. See page 25.
Noisy stereo reception Turn Stereo off. The stereo broadcast may not be clear. See page 18.
Picture okay, no sound Press VOLUME + or MUTE to restore sound.
Make sure TV speakers are on. Details are on page 19.
Picture okay, sound poor Try another channel.
Try adjusting the Tone.
See page 18.
Change Stereo to off. The stereo broadcast may not be clear. See page 18.
No stereo on stereo station Make sure Stereo is turned on. See page 18.
TV Turns on or off
Turns off by itself Check Sleep Timer. See sleep timer on page 22.
Wait 30 seconds and turn on again, a power surge may have occurred.
Check Alarm Off time. See alarm clock on page 23.
Turns on by itself Check Alarm On Time. See alarm clock on page 23.
Check clock time. See clock on page 3.
Does not turn off at
Alarm Time
Make sure alarm is turned on or off. See alarm clock on page 23.
Check clock time. See clock on page 3.
29