With vcr: setting the vcr1 channel, Select the setup menu, Diagram used from the connection guide – Sears 274.4394859 User Manual
Page 11: Set vcrl channel to, Using your tv and remote
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
With VCR: Setting the VCR1 Channel
The VCR 1 Channel works with the VCR1 button on the remote. If the
VCR 1 Channel is set, pressing VCR selects the channel to see the VCR
picture. The VCR 1 Channel setting depends on which diagram you have
used from the Connection Guide. If you want to turn this feature off, set
the VCR 1 Channel to Disable. Refer to the chart below for your setting.
Using Your TV and Remote
1. Select the Setup Menu
13
Controls Alarm Adjust Setup
English Français Español
Autoprogram
Label: 13
. Clear
Channel Memory: 13 Stored
Cable/Air: Cable
VCR 1 Channel: 03
A. Press TV to set the remote to
control the TV.
B. Press MENU»PROG to select the
Setup menu. This menu is
white.
2. Highlight VCR 1
Channel
13
Controls Alarm Adjust Setup
! English Français Español
; Autoprogram
^ Label: 13
Clear
! Channel Memory: 13 Stored
: Cable''Air: Cable
A. Press MOVE ▼ to highlight the
VCR 1 Channel.
B. Press MOVE ► to highlight the
charmel.
3. Enter channel number
13
Controls Alarm Adjust #etup
EngMi Français Espafloi :
Autoprogram
Label: 13
Clear
Channel Memory: 13 Stored
Cable/Air; Cable
Enter channel 00, 03, or 04. Choose
your setting from the chart below.
Press MOVE ▼ until "Disabled" is
displayed to turn the feature off.
Diagram used from the
Connection Guide:
IB, 1C, 2B, 2C, 3B, 3C, 4C, 5C
4B, 5B
Set VCRl Channel to:
00
3 or 4 (same as 3/4 switch)
—