Sears 149.213340 - Manual (Page 5)

TOOLS REQUIRED
8 -inch AdjusSable
Wrench
UNPACKING AND CHECKING CONTENTS
Model 149.213340 Radial Drii! Press is shipped complete in one
carton. Carefully unpack and separate parts from packing material
Check loose parts against Table of Loose Parts on page 5 and parts
list on page 15. If any parts are missing or damaged, do not attempt
to assemble Radial Drill Press, plug In power cord or turn on power
switch until replacement parts are obtained and properly installed..
Some parts such as the table and base are coated with rust preven­
tative that can be removed with a soft doth soaked in kerosene Do
not use acetone, gasoline, or lacquer thinner; these are dangerous
and may also damage the plastic and rubber parts of the Radial Drill
Press.
Apply a coating of paste wax to the table and base work surfaces
REF
TABLE OF LOOSE PARTS
NO. DESCRIPTION QTY.
1 Base Assembly
1
4 Column and Flange Assembly
1
5 MB X 25mm Hex Head Bolls 4
6 & 16 Table Bracket and Table 1
9 Worm Pinion 1
15 Vertical Rack 1
1 0 Lilt Handle
1
— Drill Head Assembly
1
14 Lock Handles 3
37 & 38 Handle Bars and Knobs 3
46 Chuck and Key 1
96 5/16-18 X 5" Carriage Bolts 2
97 5/16-18 Wing Nuts 2
95 Owner’s Manual (not shown) 1
96 5/32" Hex Handle 1
99 3mm Hex Handle 1
8 8 Lock Shoe with Recess 1