Assembly, To assemble remaining components, Checklist – Sears 580.75151 User Manual

Page 8

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

ASSEMBLY

Using a 5/16" (8mm) wrench, attach wire support to top
two holes of guide handle wito #10 self-drilling screws
and #10 flat washers (Fig. 3). The hose minder should
be to the left and gun holder to the right. Be sure loop
of support is pointing upward. Place viriyl cap onto gun
holder.

TO ASSEMBLE REMAINING COMPONENTS

iMPORTANT: YOU MUST ASSEMBLE WAND AND AT

TACH ALL HOSES BEFORE YOU START ENGINE.
STARTING

ENGINE

WITHOUT

ALL

HOSES

GON-

MCf'Tirn AMD VA/ATPR oilPPI IFD W(l I HAMAOF

I ^ I

rej 1 L» V IF rv * fl

f L

*-# L*

/ V W f L* L* L/ VI # # Lm

PUMP.

Remove the red cap
from the oil fill hole on
the pump and insert Oil
Fill Cap (Fig. 4).

(^25^ PUMP

f DIPSTICK

FIG. 4

Included with this unit is a Quick-Connect fitting you

attach to Water Inlet. The quick-connect includes two
parts — a Male Connector factory-installed on water
inlet and a Female Connector (Fig. 5). Remove male

connector. Reattach male connector to water inlet and
attach female connector to garden hose.

Unravel high pressure hose, remove plastic cap on end
of hose and check other end of hose to see that threads
are properly covered with teflon tape. If tape is not
properly applied, reapply it so threads are fully covered.
The tape seals the connection from hose to gun and
wand assembly.

Attach fitting with teflon tape to gun and wand assembly
(Fig. 6). You may want to spin gun or spin hose to
secure connection. Tighten hose using 11/16“ and 7/8"
wrenches.

FIG. 6

Attach the other end of the high pressure hose to high

pressure fitting on pump (Fig. 7). Tighten with 15/16"
(24mm) wrench.

FIG. 5

o To attach the adjustable nozzle refer to Operation

section, Fig. 1Ü.

CHECKLIST

» Check that fasteners you used to install wheel kit and

handles are tight. Vibration during operation may

loosen fasteners that are not tight enough.

• Check for proper hose connections (high pressure and

water supply) and for tight connections and that there

are no kinks, cuts, or damage to high pressure hose.

a Provide proper water supply (not to exœed 140“F).

« Be sure to read "Safety Rules” and “Operation" sec

tions before using the pressure washer.