Sears KENMORE 385. 1254180 User Manual
Page 35
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SECTION
3. ■
LEARN THE-STITCHES
o Sew a Button
Set the Machine
Siitch selector
Top thread tension
control i to 4
Stitch length
Any number
(not necessary
to adiusil
Darning plate
Use the darning plate for button sewing (see p-^).
__
1. Set the pattern selector at " @ZD
2.
Align the both holes of the button with the slot of the foot and place the left
hole of the button just below the needle point
3.
Lower the foot and turn the pattern selector to zigzag until the needle point
comes just above the right hole of the button,
4.
Sew about five stitches and raise needis.
5.
Set the pattern selector at " (g ) " again and sew a few stitches to lock
thread.
To strengthen the shank, cut the
threads leaving a 8 inches tail. Bring
the needle thread down through the
hole in the button and wind it around
the shank.
Draw the thread to the underside and
knot
33