beautypg.com

User check list – Hoover CONVERTIBLE U4057 User Manual

Page 18

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

USER CHECK LIST

This appliance was inspected thoroughly and was in good operating condition
when it was shipped from the factory. If a minor problem develops, it usually

can be remedied quite easily when the cause is identified. Accordingly, this
check list is provided for your convenience.

Problem

Possible cause

Possible solution

Cleaner
won't
run

1. Not firmly plugged in.

2. No voltage in wail plug.
3. Blown fuse/tripped breaker.

1. Plug unit in firmly.

2. Check fuse or breaker.
3. Replace fuse/reset breaker.

Cleaner
won't

pick up

1. Broken or worn belt.

2. Agitator brushes worn.
3. Bag full.
4. Bag not opening.
5. Incorrect carpet adjustment

lever setting.

1. Replace belt.

2. Replace brushes.
3. Change throw away bag.

4. Open bag by pulling pleats.
5. Set carpet adjustment lever for

type carpet being cleaned.

Cleaner

hard

to push*

1. Incorrect carpet adjustment

lever setting.

1. Set carpet adjustment lever for

type carpet being cleaned.

If the problem persists, check the telephone book for a HOOVER COMPANY

listing, or consult the white insert accompanying this manual for the nearest
location where approved service and genuine HOOVER replacement parts may

be obtained. For service under Warranty, follow the instructions in the war­
ranty provided with this product.

Always identify your Cleaner by model number when requesting information
or ordering replacement parts. (The model number appears on the bottom of
the cleaner.)

If further assistance is needed, contact the

Hoover Company Customer Rela­

tions Department, North Canton, Ohio 44720, 216-499-9200.

Lubrication

The motor is equipped with one ball bearing and one sleeve bear­

ing. The ball bearing should be lubricated, but the sleeve bearing should never
be lubricated.

The agitator is equipped with two ball bearings that should be lubricated
periodically.

Ball bearings should be checked annually and lubrication of alt ball bearings

should be performed by the Hoover Factory Branch Service Center, or the

Authorized Warranty Service Dealer, as listed on white insert.

17