How to replace the brushes, Shaft, End assembly – Hoover CONVERTIBLE U4057 User Manual

Page 17: Locator, How to replace brushes, Shaft end assembly

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

How to replace the brushes

Disconnect the cleaner from electrical outlet.

1. To replace worn brushes, remove bottom plate, belt and agitator, following

directions given on preceding pages.

2. Turn end plates of agitator in
opposite directions to loosen.

j £■'

END
SECTION

END PLATE

3. Continue turning until one end

comes off exposing the end section.

Then, pry out end section exposing
the shaft.

SHAFT

END

ASSEMBLY

4. Gently tap the end of the shaft
with hammer to loosen opposite
end.

5. Puli shaft and end assembly from

agitator.

LOCATOR

6. Remove brushes by pulling them
from agitator. Slide new brushes

into channels. Push them in as far
as possible.

7. To reassemble, replace shaft and
end assembly lining up the locator
with the slot in the agitator. Press

into place. Place remaining end sec

tion over the shaft end, lining up the

locator and slot. Press into place.
Screw end plate on and tighten.