Winco RDP-110 - Manual (Page 15)

9318100990 Rev E RDP-110 Human-Machine Interface 2-3
E Alarm Conditions
• Red LED illuminates when a low coolant level has occurred.
•
Red LED illuminates when the high coolant temperature alarm setting is exceeded
•
Red LED illuminates when the low oil pressure alarm setting is exceeded.
• Red LED illuminates when the overcrank setting is exceeded.
• Red LED illuminates overspeed setting is exceeded.
•
Red LED illuminates when the emergency stop is activated
•
Red LED illuminates when the airbox damper contact is closed.
• Red LED illuminates when the Fuel Leak/Sender Failure is detected (DGC-2020,
500, and 1000) or Airbox is closed (DGC-2000).
• Red LED illuminates when a sender failure is detected.
F Red LED illuminates when the DGC is not in AUTO.
G Audible alarm annunciates when DGC is not in AUTO and when alarms and Pre-alarms
occur.
H Dashed line indicates the front panel outside edges when flush mounted.
RDP-110 CONNECTIONS
Compression type terminal strips make wiring the RDP-110 a simple task. It is necessary to remove the
front panel to access the printed circuit board and terminal strips. These terminal strips connections
accept one #10 or two #14 AWG wires or smaller. These operations are made even easier by user
friendly labeling of the terminal strips on the printed circuit board. Once wired, these connectors can be
quickly disconnected to facilitate RDP-110 replacement for out of circuit testing or maintenance. Each
connector is keyed to prevent improper connections. Figure 2-3 shows the RDP-110 rear panel terminal
connections.
Figure 2-3. RDP-110 Remote Display Panel with Front Panel Removed