Viconics H200 User Manual

Page 4

04/06/04 LIT-H200X-E02 H200.doc

TABLE 2: HUMIDISTAT ACCESSORIES

H50

Internal humidity sensor for H200 humidistat and for H80 remote wall sensor.

H60

Duct humidity sensor to mount directly onto the back of any H200 humidistat.

H71

Duct humidity sensor to mount directly onto the supply or return of the ventilation duct.

H80

Wall humidity sensor to mount in any remote location.

H263

Programming tool for troubleshooting, viewing and modifying humidistat parameters.

008-0089

Replacement lexan (cover sticker) for H200 humidistat.

024-0048

Humidistat replacement base with connector (H50 internal humidity sensor not included).

H50 INTERNAL SENSOR

H60 DUCT SENSOR

H71 REMOTE DUCT SENSOR

This humidity sensor can be
mounted directly on 024-0048
humidistat base.

This humidity sensor can be
mounted directly onto the back of
any H200 humidistat, with the
supplied hardware. This
transforms the humidistat into a
duct-mounted humidistat.

This humidity sensor can be
mounted directly onto the supply
or return of the ventilation duct.
The H200 may be located on the
wall with humidity sensing from
the remote H71 sensor location.

H80 REMOTE WALL SENSOR

H263 PROGRAMMING TOOL

This humidity sensor can be wall
mounted in any remote location.
The humidistat may be located
on the duct or other location, with
humidity sensing from the H80
sensor location.

This tool is used to change
humidistat parameters. It is also
useful for troubleshooting. Just
plug it in the humidistat through
the casing. See page 6 for more
details.

WARNING:

All H200 humidistats are
intended to control equipment
under normal operating
conditions. Where failure or
malfunction of H200 series
humidistats could lead to an
abnormal operating condition
that could cause personal injury
or damage to the equipment or
other property, other devices
(limit or safety controls) or
systems (alarm or supervisory)
intended to warn of, or protect
against, failure or malfunction of
H200 humidistats must be
incorporated into and maintained
as part of the control system.