Viconics VT8000 Series Device Replacement Guide - Manual (Page 6)

6 VT8000 Controller Replacement Guide
©
2
01
4 V
ic
onc
is
T
ec
hno
lo
gi
es
. A
ll r
ig
ht
s r
ese
rv
ed
.
Viconics Technologies Inc. | 9245 Langelier Blvd. | St.-Leonard | Quebec | Canada | H1P 3K9 | Tel: (514) 321-5660 | Fax: (514) 321-4150
028-0454-00 www.viconics.com | [email protected] November 2014
6. Mount the front plate on the existing back plate installed on the wall.
NOTE: Ensure small plastic projections at top of front plate align with notches at top of back plate.
7. Push on front plate bottom two corners to secure unit in place (Figure 3).
8. Wait for Room Controller to power up.
9. Use the table on earlier pages to re-configure your parameters such as sequence of operation, pipe number, occupied
heating/cooling setpoints.
10. Make sure Channel, Pan ID, and Com address match previous settings before replacement to bring Room Controller
back online.
Note: In the event a new ZigBee module is being used instead of the pre-exsisting one, the Room Controller must
be bound to the MPM again.
Figure 3 Secure Unit