Vt8000 controller replacement guide – Viconics VT8000 Series Device Replacement Guide User Manual
Page 4
4
VT8000 Controller Replacement Guide
©
2
01
4 V
ic
onc
is
T
ec
hno
lo
gi
es
. A
ll r
ig
ht
s r
ese
rv
ed
.
Viconics Technologies Inc.
|
9245 Langelier Blvd.
|
St.-Leonard
|
Quebec
|
Canada
|
H1P 3K9
|
Tel: (514) 321-5660
|
Fax: (514) 321-4150
028-0454-00
www.viconics.com
|
November 2014
Object Name
Default Configurations
Current Configurations
before Replacement
Units (Temperature Scale)
°C
Low Backlight
60%
Night Backlight
5%
RH display
Enabled
The below parameters are not accessible through the Setup menu in the VT8300/VT8350. However, they can be modified via the front
end Room Controllers once the device is online.
Object Name
Default Configurations
Current Configurations before
Replacement
More BACnet/ZigBee objects
System Mode
Sequence#1 (Heat only)
Fan Mode
N/A
Short Screen Message (BACnet only)
Off
Long Screen Message (BACnet only)
Off
Display Long Screen Message
No
Heating Demand Limit
N/A
Cooling Demand Limit
N/A
No Activity Sleep Mode
Disabled
Depending on Firmware version of MPM, some properties (such as Display Long Screen Message) do not show up in the Objects list.
NOTE
This document has one procedure to remove a Room Controller on a ZigBee Network and one procedure to remove a Room Controller
on a BACnet Network. Make sure to use the correct procedure.