Viconics VT8000 Series Device Replacement Guide - Manual (Page 5)

5
Viconics Technologies Inc. | 9245 Langelier Blvd. | St.-Leonard | Quebec | Canada | H1P 3K9 | Tel: (514) 321-5660 | Fax: (514) 321-4150
028-0454-00 www.viconics.com | [email protected] November 2014
VT8000 Controller Replacement Guide
©
2
01
4 V
ic
onc
is
T
ec
hno
lo
gi
es
. A
ll r
ig
ht
s r
ese
rv
ed
.
ZigBee Network
1. Remove security screw on bottom of Room Controller cover.
2. Open unit by pulling on bottom side of Room Controller cover (Figure 1).
3. Remove cover.
4. Open new VT8300/VT8350 Room Controller box and separate back plate from front plate.
5. Remove ZigBee communication module on back of front plate and install on the back side of front plate of
new Room Controller (Figure 2).
Figure 1 Cover
Figure 2 Communication Module