Vexilar Flasher Family 2013 - Manual (Page 35)

35
Cable Storage and Cleats
Use the cable handle as
your cable storage and the
tie-down cleats on either side
to keep it in place and out of
your way.
Transducer Holder
Store the transducer in the special holder
above the battery. The holder is designed
to accept all styles of Ice-Ducers.
Battery Compartment
To remove the battery, remove the flasher
from the carrying case, then the transducer
holder by removing the two mounting screws.
Easy Charge Jack
Charge the battery here. Connect
the Easy Charge Jack to begin
the charging process. Be sure to
disconnect from battery when putting
the system away for more than a
week, as the DD-100 will drain your
battery, but remember to re-connect it
before recharging once it comes out of
storage or the battery will not receive
a charge. .
Accessories
Use the pre-
drilled holes for
Vexilar add-on
accessories, such
as the FlexLight,
or Tri-Beam
Transducer. See
pages 52 - 56.
Eye-Bolt
Insert the transducer
support eye-bolt here,
the pack’s front or
far side. Be sure to
remove the float from
the transducer cable
when using the eye-
bolt.