VACUUBRAND VACUU·CONTROL - Manual (Page 43)

Operation
43 BA-N°: 999279/17.10.2014
Remonte control/
Control mode
6.4 Remote control – mode “Control”
WARNING
Misuse can cause physical injury or damage to
property
Misuse or improper operation causes harm and can
lead to physical injury or damage to property.
>
Observe all safety instructions of these instructions
for use and the safety instructions of the remote
controlled device.
>
Use the system only for its intended use.
>
Use the system only with knowledge to function and
operation.
>
Never operate critical processes by remote control!
>
Prevent hazards caused by parallel entries, such
as simultaneous operation via several end devices.
Arrange operation by remote control with colleagues.
>
Set up password protection
 see chapter: “7.1.2 Password management”.
In addition to the status display, the control elements are enabled
for operating by remote control = “Control” mode. This means you
have direct access to the vacuum system.
Mode “Control” is intended for personnel with read‑/write permis-
sion.
Switch to control mode
> Click on selector switch “Control” on the upper left side.
5
Selector switch “Control“ is marked.
5 Display with current pressure appears.
>
Ask your system administrator for the password, if an
access window appears.