VACUUBRAND CVC 3000 detect - Manual (Page 50)

page 50 of 74
This screen-shot shows the factory-set values.
+
Autostart: If ”Autostart” is set to ”On” the controller restarts a running
process automatically after a mains failure. If this is unwanted, set
”Autostart” to ”Off”.
Attention: If ”Autostart” is preselected, the process starts
immediately after power failure without pressing any fur-
ther key. It is the user’s responsibility to ensure that no
dangerous status of the system due to the automatic start-
up can occur and to provide appropriate safety measures.
If necessary, the user has to check prior to starting the
process if the option ”Autostart” is enabled.
+
Defaults: If ”Defaults” is set to ”Load”, the controller is reset to factory
set values. All stored programs and parameters are deleted.
Configuration
Adjustment 760 Torr
RS-232...
Sensors...
Display...
Autostart Off
Defaults Cancel
- - - - - - - Back - - - - - - -