VACUUBRAND MV 2 VARIO - Manual (Page 3)

page 3 of 41
Documents are only to be used and distributed completely and unchanged. It is strictly the users´ responsibility to check
carefully the validity of this document with respect to his product. manual-no.: 999035 / 15/12/2009
Attention! Important notes!
Not permitted! Misuse may cause damage.
Caution! Hot surface!
Isolate equipment from mains.
Note.
Contents
Safety information! .................................................................................................... 4
Technical data ............................................................................................................ 8
Description .............................................................................................................. 12
Notes on operation .................................................................................................. 14
General view basic setups ...................................................................................... 16
How to configurate the controller .......................................................................... 17
Basic setup TURBO•MODE ..................................................................................... 19
Basic setup pressure control ................................................................................. 21
Basic setup continuous pumping .......................................................................... 23
Interface parameters ............................................................................................... 25
Read commands ..................................................................................................... 26
Write commands ...................................................................................................... 27
Accessories ............................................................................................................. 28
Troubleshooting ...................................................................................................... 29
Readjustment .......................................................................................................... 31
Replacing diaphragms and valves ........................................................................ 32
Calibration in the factory ......................................................................................... 37
Notes on return to the factory ................................................................................ 38
Health and safety clearance form .......................................................................... 39