VACUUBRAND MV 2 VARIO - Manual (Page 18)

page 18 of 41
Documents are only to be used and distributed completely and unchanged. It is strictly the users´ responsibility to check
carefully the validity of this document with respect to his product. manual-no.: 999035 / 15/12/2009
Setting the basic setup
Starting the program:
➨ Press key MODE while switching on the controller.
☞ The basic setup ”TURBO•MODE” (factory-set) is displayed
on the LCD.
To change the basic setup:
➨ Press key ▲ or ▼ until the symbol of the desired basic
setup is displayed.
➨ Press key START/STOP to confirm the selected basic setup.
TURBO•MODE pressure control continuous pumping
☞ The symbol of the air admittance valve is displayed and
”yes” or ”no”.
➨ Switching between ”yes” or ”no” is possible by pressing key
▲ or ▼.
➨ Confirm the selection ”yes” or ”no” by pressing key START/
STOP.
How to change the pressure units
+
mbar
Torr
hPa
(mains switch)
Press key p ▲ or p▼ during switching on.
☞ The pressure units are displayed, the pressure unit as from
last operation is flashing.
➨ Press key p▲ or p▼ to change pressure unit. Press key
START/STOP when controller displays the desired pressure
unit to finish the operation mode.
p
MODE
+
(mains switch)
The controller is ready to start.