USL UPC-28C - Manual (Page 11)

- 10 -
UPC-28C Instruction Manual Ultra Stereo Labs, Inc.
and subnet mask for the IRC-28C. If desired, a netbios hostname can also be set.
Since DNS is not used by the IRC-28C, these fields can be left unchanged.
13. Once the network configuration has been entered, press Save IP Con-
fig and Reboot. The IRC-28C will reboot at the new IP address.
14. Connect the IRC-28C to your DCS control network.
15. Reconfigure your laptop for the DCS control network and connect it.
16. You should be able to point the web browser the the new IRC-28C IP
address and see the opening screen.
Closed Caption System Operation
When captioned content is played, the IRC-28C should send captions to the
display(s) at the appropriate time. The IRC-28C tells the DCS that it is ready to
start playback when all assigned languages have data ready for transmission. If
a movie only has captions for one language, the DCS is told that the IRC-28C is
ready when language 1 (stream 0) is ready.
To restore the IRC-28C to its original state (original firmware, original IP ad-
dress settings, etc.), use a paper clip to hold down the restore button while power-
ing up the IRC-28C.
The Restore Button is visible through a vent hole on the bottom right of the
IRC-28C, when viewed from the front of the plastic side of the IRC-28C
Restore Button
System Status Page
A System Status page is available from the selections at the top of the configu-
ration page. This page shows the last 10 log entries. However, the streaming log,
described below, is more useful.
An Update Firmware page is available from the selections at the top of the
configuration page. Use this page to load new firmware into the IRC-28C. When
the update is complete, a blank page will appear on the browser. Enter the IP ad-
dress of the IRC-28C in the browser URL field to reconnect to the IRC-28C and
verify that the version number has changed to the new version. All user configura-
tion is saved through a firmware update.
Update Firmware Page