USL UPC-28C - Manual (Page 10)

- 9 -
UPC-28C Instruction Manual Ultra Stereo Labs, Inc.
Starting on the left side of the screen, configure the system using these steps:
1. Set the DCS IP address. This is the Digital Cinema Server IP address
the IRC-28C will use to get data from the DCS.
2. Set the timeline offset to 0 Edit Units. If desired, this can be changed to
make captions earlier or later. A positive number makes captions appear earlier.
3. Set the caption protocol to SMPTE. The Doremi protocol is also sup-
ported, but Doremi also supports the SMPTE protocol.
4. Set ACS Reboot on Lease Terminate to “no”. On rare occasions, it may
be necessary to set this to yes. If you find the IRC-28C must be rebooted between
shows, set this to yes.
5. Set the IR Caption Carrier to “On Connect to DCS.” This will shut down
the caption carrier when the DCS is shut down.
6. Set the delay before offline text. This is the number of seconds after
playout stops that the offline text appears.
7. Set the offline text. This text appears on caption displays after playout
stops. This is typically a welcome message. The text can be up to 3 lines of up to
32 characters each.
8. Select language priorities. As discussed above, the Auxiliary Resource
Presentation List includes the language of each resource. The IRC-28C supports
the display of up to three languages on IR receivers. The IRC-28C searches the
Auxiliary Resource Presentation List for the languages in the language priority list.
If the first language in the priority list is not found, the Auxiliary Resource Presenta-
tion List is searched for the next language, etc. Languages are assigned to IR data
streams and web streams according to priorities selected here. The first language
found is assigned to stream 0 (language 1). Do NOT include the same language
in more than one priority position. If the Auxiliary Resource Presentation List does
not include language attributes for the caption files, the captions will be sent to
stream 0. If the Auxiliary Resource Presentation List has language attributes for
the caption files, but the attributes are not standard (for example “English” instead
of “en”), the first three languages found will be used. The system will search for
nonstandard language attributes only if standard language codes were not found.
9. Once caption configuration settings have been made, click on the save
button in the bottom of that field to save the settings.
10. If desired, user data that is not used but is displayed can be set and
saved.
11. If desired, the admin password can be set and saved. The password
has to be entered in both fields, then Save New Password pressed.
12. Moving to the right side of the screen, set the IP address, gateway,