Coleman 9280A108 - Manual (Page 2)

3 Clip Tent to Frame
–Starting at the top rear of the tent,
attach the tent to the frame using
the frame clips. (illus. 7 & 8)
–Unzip front door, and standing in
the open door, attach the remainder
of the tent ridge frame clips to the
ridge pole. (illus. 7 & 8)
–Attach all the side frame clips to
the frame. (illus. 7 & 8)
4 Attach Rainfly
–Drape rainfly over the tent frame.
–Insert frame poles in the front
and rear into reinforced pockets
located at the center edges of the
underside of rainfly. (illus. 9 & 10)
–Attach rainfly to the frame poles
with attachments.
– Attach “S” hooks to the ring of the
pin & ring system.
–Attach corner guylines to the
guy triangles at the rainfly
corners. Stake out guylines
away from the tent at an
angle. (illus. 10)
– Attach side guylines to the ring
on the sides of the rainfly
and stake out. (illus. 11)
–Tent wall can attach to guyline
and/or rainfly to expand interior
space. (illus.10)
illus. 8
Assembled tent without rainfly. Note the
frame clips located on tent.
illus. 7
Frame clip
attached to
tent frame.
Note: Fly pole can be turned under and secured w
velcro to ridge pole when rainfly is not in use.
illus. 10
Completed tent with rainfly.
Note the guylines on each
corner (4) and side guylines (2
Attachments located on
under side of rainfly
Clips to
tent wall
illus. 9 Insert rainfly
pole piece into
pockets on undersid
of rainfly
PRINTED IN CHINA
Rev. 7/03
Things You Should Know
•
Under certain conditions (cold weather, high humidity, etc.)
condensation will form on the inside surfaces of your tent. Condensation is
caused by water vapor from your breath, perspiration, or any wet clothing
inside your tent. It is NOT LEAKAGE through the tent fabric. It can be
minimized by removing wet clothing from your tent and by providing good
ventilation through the tent.
•
Never store tent, even for a short period of time, without drying it thorough-
ly and brushing off caked dirt. Do not pack stakes or poles inside your tent.
Use a separate storage bag.
•
STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF.
NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO
REMOVE STAKE.
•
TENT POLES SHOULD NOT BE LEFT TELESCOPED
TOGETHER DURING STORAGE.
•
Seam sealer has not been provided with your tent. We recommend seam
sealing your tent prior to camping. Seam sealer may be purchased through
your local retailer or at your local sporting goods store.
•
Do not leave your tent set-up for weeks at a time, be aware that expo-
sure to the ultraviolet rays of the sun can seriously damage material and/or
cause it to become discolored.
•
See owners manual for more tips.
WARNING: KEEP ALL FLAME AND HEAT SOURCES
AWAY FROM THIS TENT FABRIC. This tent meets the flammability
requirements of CPAI-84.The fabric will burn if left in continuous contact with
any flame source.The application of any foreign substance to the tent fabric may
render the flame-resistant properties ineffective.
THE COLEMAN CO., INC.
3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com
MADE IN CHINA
illus. 11 Stake out tent
with adjustable guylines.
Slide the disc up the rope
to tighten guyline.