USL DAX-202 User Manual

Page 3

Text mode
Original mode

DAX-202 User Manual

Page3

Source

DB25 pins

Dolby 7/8

6 / 19

DCI 7/8

7 / 20

DCI 15/16

1 / 14

DCI 9/10

18 / 6

DCI 13/14

15 / 3

BNC

—

Setup

1. Using the chart below, determine where the HI/VI-N AES sources will

come from.

2. Remove the four cover screws holding the DAX box together.

3. Close the PAIR of DIP switches that correspond to your source selec-

tion. See Figure 3.

4. Replace the cover screws.

5. Connect the HI output of the cinema processor to the HI input on the
Phoenix connector.

Assemble the Phoenix Connector Plug as Required:

6. Connect the VI-N and HI outputs to the IR or RF transmitter. If the

system has an unbalanced input, be sure to jump the “ - ” signal output

Pin

Function

Comments

VI-N + (Output)

VI-N - (Output)

Connect to Gnd for unbalanced

3 Gnd

HI - (Output)

Connect to Gnd for unbalanced

HI + (Output)

Earth Gnd

HI - (Input)

Connect to Gnd for unbalanced

HI + (Input)

HI CTL (Control)

Connect to Gnd for AES

10 Gnd