Crestron electronic STX-1700CXP - Manual (Page 34)

2-Way RF Wireless Touchpanel Crestron STX-1700CXP
30 • 2-Way RF Wireless Touchpanel: STX-1700CXP Operations Guide - DOC. 6144
Appendix A: Engraveable Pushbutton Installation
The STX-1700CXP is supplied with ten pushbuttons, pre-labeled with standard
legends. As an option, custom-engraved buttons can be designed and obtained by
using the Crestron Engraver software. Version 2.0.1.5 or later is available from the
Downloads | Software Updates section of the Crestron website (
www.crestron.com ).
Perform the following to install engraveable pushbuttons on the STX-1700CXP. A
#1 Phillips screwdriver is required. Refer to the illustration below.
1. Remove the battery, and place the touchpanel face down on a clean work
surface.
2. Remove the four screws securing the front bezel to the base, and return the
unit to its normal position (hold the bezel and the base of the unit together at
the sides while turning it over, to prevent the assembly from falling apart).
3. Lift the bezel from the touchpanel, and remove the pushbuttons being
replaced. Note that the pushbutton sets fit snugly on the membrane switch.
(Refer to the following Notes.)
4. Put the new pushbuttons in place (refer to the following Notes), press firmly
to ensure they are seated, and place the bezel back in position.
NOTE: The rear of the pushbuttons are marked TOP 1-5 and 6-10 to ensure correct
orientation when installed. Do not remove the plastic frame connecting the buttons
together.
NOTE: Some touchpanels are supplied without any adhesive holding the membrane
switches is place. For these units, after assembling the new pushbuttons to the
membrane switches, carefully position the switch/pushbutton assemblies on the
printed circuit boards–edges should be aligned, and place the bezel over the
pushbuttons to hold them in place.
5. Hold the bezel in position and turn the unit over on its face.
6. Reinstall the four screws to secure the bezel to the base. Tighten the screws,
being careful not to strip the threads.
7. Reinstall the battery and verify that the pushbuttons function properly.
Engraveable Pushbutton Installation Diagram
Bezel
Pushbuttons
Top view with
bezel removed
5
10
Screw
Battery
Screw
Bottom view
Membrane
Switch