Trending Accessibility BARRIER FREE SHOWER PAN - Manual (Page 10)

10
5.- Using a power drill with a 1/4” diameter Carbide bit, drill through the wall tile the three (3)
mounting holes for each flange
.
Recommended tools for installation:
THIS COMPLETES THE INSTALLATION OF THE SEAT
7.- Place the seat against the mounting wall with each hinge aligned to the mounting holes.
Utilizing the six (6) #10 x 2” Stainless Steel screws, place a Phillips screw driver into
your power drill and securely tighten each of the six (6) screws.
1/4” Power Drill
1/8” drill bit when drilling through fiberglass
(Use a 1/4” Carbide drill bit when drilling through ceramic tile)
#2 Phillips Screw Driver and/or Phillips drill insert
1/2” Open end wrench or a small Crescent wrench
Tape measure
Pencil/pen
Center Punch
Silicone Caulk
6.- Apply silicone caulking around and inside each drilled hole before installing the seat.
Note: When installing the seat onto a Ceramic Tiled wall, prior to drilling the three (3) mounting holes
for each flange that you previously marked, use a center punch and lightly chip a small hole in the
center of each of the three hole locations. (For drilling holes through tile, you require a 1/4” Carbide
tipped drill bit). Only drill through the tile and base materials.
DO NOT DRILL THROUGH THE BACKING.
Your seat with swing down legs is fully assembled. Remove it from the box and proceed as follows:
These primary instructions are for installing the seat onto a CERAMIC TILED WALL. The tiles wall
must be properly constructed so as to be rigid. In addition, it is MANDATORY that wood
reinforcements be installed to the framing studs behind the wall board and tile to provide a solid
mounting surface when fastening the seat to the wall.
(This style seat has four (4) adjustable height legs)
1.- Choose the height of the seat you want. Barrier Free style showers will typically have fold up
seat installed at 17” to 19” height.
2.- After selecting the height you desire, adjust each of the four legs to that height while
maintaining the seat in a level position. Lock each of the lock nuts.
3.- Place the seat against the wall of the shower where you want the seat to be located.
Seat may be centered on the wall for a Barrier Free installation.
INSTALLATION INSTRUCTIONS FOR SHOWER SEATS
WITH SWING DOWN LEGS
4.- With the seat placed against the mounting wall, position the two hinges to the wall.
Using a pencil, mark the three holes (3) holes in the flange onto the wall for each hinge.
Remove seat from wall.
856-488-9535 www.TrendingAccessibility.com