Trending Accessibility Shower Seats (SF1615T, SF2615T, SF2621T-LR) - Manual

www.TrendingAccessibility.com | 856-488-9535
Metal Shower Seat InstallaƟ on Guide
2012/11/28
Safety CauƟ on: Due to variances in local building codes and requirements, the installa on instruc ons
provided are only sugges ons and it is advised that you contact a qualifi ed contractor for applica on specifi c
advice.
Safety CauƟ on: This seat is intended for si ng purposes only. ONE person at a me. Do not a empt to
stand, kneel or use the seat for any other applica on other than si ng.
Safety CauƟ on: The seat is designed to withstand 400lbs. when installed properly. Improper installa on may
cause bodily harm.
Safety CauƟ on: Discon nue use of the seat if visual signs of fa gue or wear become evident. Regular
inspec ons should be made to confi rm that the seat is not pulling away from the wall. If the wall brackets start
to pull away from the wall IMMEDIATELY discon nue use and call a qualifi ed contractor.
InstallaƟ on InstrucƟ ons - Fold Up Shower Seat
Provide no smaller than a 2” x 6” header in the wall for
moun ng.
Measure from the fi nished fl oor up 12-3/4”. Center the
2” x 6” horizontally over three wall studs and with the
center of the 2”x 6” at the 12-3/4” mark.
Notch the wall studs to accommodate the header and
a ach with no less than 6 - 5/16‘ x 3” stainless steel lag
screws. (as shown in figure 1a.)
Before fi nishing the wall, and using the
dimensions of your seat, ensure that the
two wall brackets and the top two screws
of the center wall support will line up with
the 2”x6” header, while the third bo om
screw of the center wall support will line
up with the middle wall stud. (as shown in
fi gure 1b.)