Trending Accessibility Transitional & modern linear fusion shower pan recessed into concrete - Manual (Page 4)

Installation Guide
www.trendingaccessibility.com [email protected]
4
for linear shower pan recessed into concrete
Step 5
Set the Linear Fusion Shower Pan into place and
check to make sure it is level. If for some reason
you notice any rocking or flexing in the pan, you
may need to build up or shave areas. This is im-
portant to achieve proper drainage.
Step 7
To prepare for permanant installation, remove the
Pan from the surface. Apply a generous amount of
construction adhesive to the concrete floor. Place
the Pan down into position and apply pressure to
adhere the Pan to the concrete.
Step 8
Again while insuring that your Pan has remained
level, drill and countersink holes into the pan.
Using the cement achors, attach pan. Do not
aggressively screw and over tighten, as you may
force the Linear Shower Pan out of level. Your
Linear Shower Pan is now installed. Please refer
to the Liquid Membrane instructions to begin your
waterproofing and tiling.
If required you may drill and countersink
anywhere on the surface of the Linear
Shower Pan, not only the pre-marked
locations.
Step 6
Important: You must sand the top of your pan lightly
with a palm or belt sander to roughen up the surface
for proper adhesion of waterproofing.