Trending Accessibility Adjustable fusion shower pan on wood joists - Manual (Page 7)

Installation Guide
www.trendingaccessibility.com [email protected]
7
for adjustable fusion shower pan on wood joists
Step 13
Carefully set the Fusion Pan into place. Using
the 2 ½” screws provided, attach the pan. Do not
aggressively screw and over tighten, as you may
force the Fusion Pan out of level.
Pre-drill the holes for the rotating plate. Now attach
the rotating plate using the ¾” screws provided. Be
sure to match up your tick marks done in step 8.
Refer to the Cutting and Drilling guidline on page 12
Step 14
On top of existing subfloor install cement
backerboard in preparation for tiling. Make sure
that the top of the backerboard is roughly 1/8”
higher than the Fusion Pan.
Step 16
You now want to attach the Drain adapter flange
to the Fusion Pan.
First, set the adapter in place, mark the 4 holes,
and pre-drill them with a 1/8” bit.
Then apply a bead of caulk (Recommended: DAP
Dynaflex 230) to the underside of the drain adapter
flange. Lightly push the flange into place, and
screw it down using the four ¾” screws provided.
Remove any excess caulk that squeezes out.
membrane clamp
height adjustment ring
Remove the tile height adjustment ring and membrane clamp and
place to one side; these will be required later in the installation.
Gasket Clamp
Adapter Drain Flange
Step 15
Check that the Fusion Pan is level on all four sides.
Fill in any gaps around the perimeter of the pan over
1/8” with latex or acrylic caulk.
Recommended: DAP Dynaflex 230
Do not use 100% silicone.