Trending Accessibility Adjustable fusion shower pan on wood joists - Manual (Page 12)

Installation Guide
www.trendingaccessibility.com [email protected]
12
for adjustable fusion shower pan on wood joists
Adjustable Fusion Shower Pan - Cutting and Drilling guideline
Additional drilled and
countersunk screws
required if Pan is not
in contact with joists/
concrete floor.
Ensure all the cut edges are supported, then drill, countersink and screw the Pan to the joists below in around 7.87”
intervals (avoiding pipes, electric wires, etc.).
Important: Do not cut the edges that adjoin surrounding floor. Cutting the Pan may reduce flow rate pe rformance.
Maximum cut
Maximum cut
Maximum cut
Maximum cut
Additional timber Additional timber Additional timber
Fig.1
Cut using an old or disposable handsaw.
Additional fixing points
Fig.2
Cut to length.
Fig.3
Cut to accommodate diagonal wall.
Fig.4
Cut to accommodate drain point.
Fig.6
If Pan is not in contact with joist/concrete floor you must drill out
and countersink the Pan to ensure it does. Failure to do this will allow
unacceptable movement and may cause floor tiles to crack or become loose.
Fig.5
Ensure cut edges are fixed.
Do not cut into central
solid oval section
Cutting and Drilling Guidlines