Trending Accessibility Fusion shower pan surface mounted on concrete - Manual (Page 9)

Installation Guide
www.trendingaccessibility.com [email protected]
9
for fusion shower pan surface mounted on conrete
Step 22
Apply two coats of liquid waterproofing to achieve
2 mils. (roughly the thickness of a credit card)
Make sure that the “V” section of the gasket clamp
is filled with the liquid waterproofing.
Step 23
In order to set the correct height of the grate frame,
you may need to use the height extension ring
(see diagram to the right). If the height extension
ring is required, it will need to be fixed to the height
adjustment ring using solvent cement. The grate
frame can now be attached to the height adjustment
or extension ring, depending on tile thickness. This is
done by using firm pressure to clip the components
together; it is a tight fit.
“click”
1/4” to 5/8” Tile Height 5/8” - 1” Tile Height
extention ring
adjusting ring
grate frame
grate frame
adjusting ring
Best Practice
To achieve the best results, we recommend
waterproofing the whole room.
Step 21
Begin the application of the liquid waterproofing
membrane. Paint a layer of liquid waterproofing
over all taped joints. It is easiest to begin with the
walls first and then proceed to the floor area. For
consistant application, use a paint roller to apply
waterproofing to all surfaces. After first coat is dry,
re-coat.