Trending Accessibility Fusion shower pan surface mounted on concrete - Manual (Page 4)

Installation Guide
www.trendingaccessibility.com [email protected]
4
for fusion shower pan surface mounted on conrete
Step 1
For optimal performance, it is imperative there is
a level surface prior to installation of new Fusion
Pan. Check existing floor to make sure it is level. If
it is not, please correct prior to installation. Place
the Fusion pan in desired location and check to
make sure it is level.
Step 2
Once the pan is in the desired location, holding the
pan steady, trace the inner circle of the pan. This
will mark the location of the drain on the concrete,
making it easier to cut out in the next step.
Step 3
Using suitable equipment, and proper safety gear,
carefully cut a hole that is 10” in diameter. It may
be easiest to score the concrete approximately
every 1” to 2” inside your perimeter line, to make
the removal of the concrete more efficient. Now
excavate all of the remaining concrete in the
marked area.
Note: If possible, please check or mark location
of existing plumbing and electrical to avoid
damaging them.
Step 4
Place the Fusion pan into place. Once the pan
is set to the desired location, note the location
of drain and remove enough concrete for the
installation of the waste pipe, and drain body.
Reinforcement ring on
the underside of pan