Trending Accessibility Fusion shower pan surface mounted on concrete - Manual (Page 10)

Installation Guide
www.trendingaccessibility.com [email protected]
10
for fusion shower pan surface mounted on conrete
Step 25
You are now ready to tile. If you are using large
format tiles, they must be cut diagonally and laid
to follow the pitch in the Fusion Pan (From the
corners of the grate frame to the corners of the
Fusion Pan). Apply the tile adhesive, and lay the
tiles in a regular pattern.
Step 26
Once your tiling is complete. Grout the floors and
walls. Finalize by adding the drain grate.
Your Fusion Pan installation is now complete.
Enjoy!
Step 24
The height adjustment ring and floor drain must
now be fixed together using solvent cement.
Because solvent cements sets very rapidly we
strongly recommend the adjustment is done “dry”
first.
To set the permanent height of the grate frame,
place a floor tile beside the frame. Rotate the frame
until the height is about 1/16” higher (this accounts
for adhesive thickness). Now mark the position
of the adjustment ring. This mark shows the
final height position. Remove ring, apply solvent
cement, and re-align components to your marked
position. It is best to hold securely until pieces are
fully bonded.