beautypg.com

Installation guide, For fusion shower pan on wood joists, Step 16 – Trending Accessibility Fusion shower pan on wood joists User Manual

Page 7: Step 13, Step 14, Step 15

background image

Installation Guide

www.trendingaccessibility.com

[email protected]

7

for fusion shower pan on wood joists

Step 13

Attach the drain adapter flange to the Fusion Pan.

First, set the adapter in place, mark the 4 holes,

and pre-drill them with a 1/8” bit.

Then, apply a bead of caulk (Recommended: DAP

Dynaflex 230) to the underside of the drain adapter

flange. Lightly push the flange into place, and

screw it down using the four ¾” screws provided.

Remove any excess caulk that squeezes out.

membrane clamp

height adjustment ring

Remove the tile height adjustment ring and membrane clamp and

place to one side; these will be required later in the installation.

Step 14

Make your final connections to the drain. First

apply a bead of caulk (Recommended: DAP

Dynaflex 230) to the underside of the strainer body.

Pass the strainer through the drain adapter flange,

and tighten. Make sure connection is snug but do

not over tighten.

Step 16

Begin taping the wetroom floor at the interior corners

of the Fusion Pan using the corner pieces of the

crack isolation tape provided. Using a paint brush or

trowel, slather liquid waterproofing into corner, press

piece into place, then apply liquid waterproofing on

top. Make sure to smooth out any creases. Repeat for

additional corners.

Step 15

You will now begin waterproofing the wet room.

BEST PRACTICE: To achieve the best results, we

recommend waterproofing the whole room.

Minimum requirements, shown in these

instructions, show you that you only have to

waterproof the shower zone, which is 6 ½ feet high

and about 2 feet outside of the showering area.

Materials needed for wet room waterproofing.

Gasket Clamp

Adapter Drain Flange