Trending Accessibility Fusion shower pan on wood joists - Manual (Page 10)

Installation Guide
www.trendingaccessibility.com [email protected]
10
for fusion shower pan on wood joists
Step 26
The metal grate frame can be rotated to match the
direction of the tile.
You are now ready to tile. If you are using large
format tiles, they must be cut diagonally and laid
to follow the pitch in the Fusion Pan (From the
corners of the grate frame to the corners of the
Fusion Pan). Apply the tile adhesive, and lay the
tiles in a regular pattern.
Step 27
Once your tiling is complete, grout the floors and
walls. Finalize by adding the drain grate. It is a
friction fit and must be pressed all of the way in.
Your Fusion Pan installation is now complete.
Enjoy!
Step 25
The height adjustment ring and floor drain must
now be fixed together using solvent cement.
Because solvent cements sets very rapidly we
strongly recommend the adjustment is done “dry”
first.
To set the permanent height of the grate frame,
place a floor tile beside the frame. Rotate the frame
until the height is about 1/16” higher (this accounts
for adhesive thickness). Now mark the position
of the adjustment ring. This mark shows the
final height position. Remove ring, apply solvent
cement, and re-align components to your marked
position. It is best to hold securely until pieces are
fully bonded.
Step 24
In order to set the correct height of the grate frame,
you may need to use the height extension ring
(see diagram to the right). If the height extension
ring is required, it will need to be fixed to the height
adjustment ring using solvent cement. The grate
frame can now be attached to the height adjustment
or extension ring, depending on tile thickness. This is
done by using firm pressure to clip the components
together; it is a tight fit.
“click”
1/4” to 5/8” Tile Height 5/8” - 1” Tile Height
extention ring
adjusting ring
grate frame
grate frame
adjusting ring