Traxxas 3351 Velineon 3500 User Manual
Page 22
22 • VELINEON POWER SYSTEM
VxL-3s Setup and Operation
3. When the LED blinks red
once, release the EZ-Set
button.
4. The LED will blink and
then turn solid green
(Low-Voltage Detection ACTIVE) or red
(Low-Voltage Detection DISABLED). The
model is ready to drive.
Selecting Race Mode
(Profile #2: 100% Forward, 100% Brakes, No Reverse)
1. Connect a fully charged
battery pack to the VXL-3s
and turn on your transmitter.
2. With the VXL-3s off, press
and hold the EZ-Set button
until the LED turns solid
green, then solid red and
then begins blinking red
(indicating the Profile #).
3. When the LED blinks red twice, release the EZ-Set button.
4. The LED will blink and then turn solid green (Low-
Voltage Detection ACTIVE) or red (Low-Voltage Detection
DISABLED). The model is ready to drive.
Selecting Training Mode
(Profile #3: 50% Forward, 100% Brakes, 50% Reverse)
1. Connect a fully charged
battery pack to the VXL-3s
and turn on your transmitter.
2. With the VXL-3s off, press
and hold the EZ-Set button
until the LED turns solid
green, then solid red and
then begins blinking red
(indicating the Profile #).
3. When the LED blinks red three times, release the
EZ-Set button.
4. The LED will blink and then turn solid green (Low-
Voltage Detection ACTIVE) or red (Low-Voltage Detection
DISABLED). The model is ready to drive.
Note: If you missed the mode you wanted, keep the
EZ-Set button pressed down and the blink cycle will
repeat until the button is released and a Mode is
selected.
D
Solid Green
C
Release
B
One blink Red
B
Two blinks Red
A
Green to Red to Off
D
Solid Green
C
Release
B
Three blinks Red
A
Green to Red to Off
D
Solid Green
C
Release
KC1211_R01 Velineon_System_Man.indd 22
12/1/09 6:02:10 PM