Top Flite TOPQ8413 User Manual

Page 4

❏

16. Install the former and the glare shield, with the glare shield

overhanging the top of the rear instrument panel by 1/8" [3.2mm]. Use
thin CA to glue the rear former to the sidewalls, and the glare shield to
the inside of the fuselage rails.

❏

17. Install the front glare shield, with it overhanging the front

instrument panel by 1/8" [3.2mm].

❏

18. Glue the seat back to the seat bottom as shown in the three

previous photos. Before installing the seats you must remove the paint
from the seat mounts on the floor. This will allow the glue to properly
adhere the seat to the mount. The seat belts are made from the black
elastic included in this kit, and the buckles are made from a chrome
trim sheet (not included). The seat belts are glued to the rear of the
seat, and to the bottom of the seat. Install both of the seats into the
cockpit with medium CA.

When you take your T-34B Mentor to the field, try to be gracious
in accepting all the praise you will undoubtedly receive. Good
Luck and Happy Flying!

Printed in USA – T349CIP01 for TOPQ8413