Toa SX-200IP - Manual

INSTALLATION MANUAL
IP INTerfAce MODULe SX-200IP
Thank you for purchasing TOA’s IP Interface Module.
Please carefully follow the instructions in this manual to ensure long, trouble-free use of your equipment.
1. SAfeTY PrecAUTIONS
• Before installation or use, be sure to carefully read all the instructions in this section for correct and safe
operation.
• Be sure to follow all the precautionary instructions in this section, which contain important warnings and/or
cautions regarding safety.
• After reading, keep this manual handy for future reference.
2. GeNerAL DeScrIPTION
The SX-200IP, designed to be installed in the SX-2100AI Audio input unit of the SX-2000 series, is an Interface
module for connection to the N-8000 series.
By connecting the SX-200IP to a network (LAN or WAN), paging announcements can be made to the SX-2000
system using the N-8000 series’ station(s) (N-8600MS and N-8610RM) employing the packet audio technology.
Each function is set by the dedicated setting software on a PC.
3. feATUreS
• Up to 8 SX-200IPs can be used per SX-2000 System.
• Paging announcements can be made to up to 8 SX-2000 systems using the SX-200IPs.
4. SPecIfIcATIONS
Network Section Network I/F: 10BASE-T/100BASE-TX (Automatic-Negotiation)
Network protocol: TCP/IP, UDP, HTTP, RTP, ARP, ICMP, IGMP
Connector: RJ45 connector for LAN
Voice sampling frequency: 16 kHz, 8 kHz (controllable on the software)
48 kHz sample rate is used for SX-2000 system only.
Quantifying bit number: 16 bits
Voice encoding method: Sub-band ADPCM, Cryptosystem
Voice packet loss recovery: Silence insertion
Audio delay time: 80 ms, 320 ms (controllable on the software)
Indicator Operation indicator (RUN)
Operating Temperature 0 to 40 ºC
Operating Humidity 90% RH or less (no condensation)
Finish Panel: Pre-coated steel plate, black, 30% gloss
Dimensions 35 (w) x 119.5 (h) x 178.4 (d) mm
Weight 150 g
Note: The design and specifications are subject to change without notice for improvement.
Indicates a potentially hazardous situation which,
if mishandled, could result in death or serious
personal injury.
WArNING
• Do not expose the unit to rain or an environment
where it may be splashed by water or other liquids,
as doing so may result in fire or electric shock.
• Should the following irregularity be found during
use, immediately turn off the power supply to the
SX-2100AI Audio Input Unit where the SX-200IP
is installed and contact your nearest TOA dealer.
Make no further attempt to operate the unit in this
condition as this may cause fire or electric shock.
· If you detect smoke or a strange smell coming
from the unit
· If water or metallic object gets on the circuit board
· If the unit falls or breaks
· If it is malfunctioning (no tone sounds.)