Toa DT-930 UL - Manual (Page 7)

7
7. RECEIVING FREQUENCY MEMORY SETTINGS
There are two methods for storing the receiving frequency in memory: manual memory preset and auto
memory preset.
The number of memory channels is 40 in total for AM and FM broadcasts.
[Keys used for operation]
7.1. Manual Memory Preset
Up to 40 AM and/or FM broadcasts can be freely assigned to CH01 through CH40 for preset memory.
Step 1. Tune in the desired frequency.
Use Auto tuning, Manual tuning, or Direct tuning method for broadcast reception. (Refer to p. 5.)
Step 2. Press the Memory key.
The "– –" indication flashes in the channel display section of the screen.
Step 3. Press the Preset Memory Enter keys (0 – 9) to designate the channel number in which the frequency
is to be stored.
(Example)
• CH01: Press [0] and [1].
• CH10: Press [1] and [0].
Notes
• Memory preset programming is completed when the screen channel indication changes from
flashing to steady ON.
• When 5 seconds has passed without key entry for the channel number, the unit reverts to the former
status.
7.2. Auto Memory Preset
Preset frequencies can be automatically assigned to CH01 - CH20 for AM broadcasts and to CH21 - CH40 for
FM broadcasts, both in order of low to high frequencies.
Step 1. Press the AM/FM Band selector key to select either AM or FM broadcast.
The selected band is displayed on the screen.
Step 2. Hold down the Memory key for 3 seconds or more.
The "AUTO" and "CH" indications on the screen flash.
Step 3. Release the Memory key.
Frequencies that can be tuned automatically are stored in memory in sequence.
Note
Preset frequencies for both AM and FM broadcasts are automatically assigned to channels CH-01-
CH20 in order of frequency band, from low to high.
Memory key
Channel number
AM/FM band selector key
Preset memory enter keys
LCD indicator
AM/FM indication