Toa DT-930 UL - Manual (Page 6)

6
6.2. Manual Tuning Mode
Step 1. Press the AM/FM Band selector key to select either AM or FM broadcast.
The selected band is displayed on the screen.
Step 2. Press the Auto/Manual Mode selector key to select the Manual tuning mode.
Extinguish the "AUTO" indication on the screen.
Step 3. Press the Frequency/Channel selector key to select either the frequency or channel.
When selecting the frequency, the "FREQ" indication is displayed on the screen.
When selecting the channel, the "FREQ" indication extinguishes.
Step 4. Press the Tuning key (UP or DOWN) to select either the receiving frequency or channel.
[Frequency setting mode]
Each time the UP key is pressed, the frequency increases by 10 kHz for AM broadcasts or by 200
kHz for FM broadcasts.
Each time the DOWN key is pressed, the frequency decreases by 10 kHz for AM broadcasts or by
200 kHz for FM broadcasts.
[Channel setting mode]
Each time the UP key is pressed, the channel number increases. While DOWN key is pressed, the
channel number decreases.
Note
Selecting an idle channel restores the unit to the former status in 5 seconds.
6.3. Direct Tuning Mode
Step 1. Press the AM/FM Band selector key to select either AM or FM broadcast.
The selected band is displayed on the screen.
Step 2. Press the Direct Tuning key to select the Direct tuning mode.
The frequency indication on the screen flashes.
Step 3. Press the Preset Memory Enter keys (0 – 9) to set the receiving frequency.
If an incorrect frequency is entered, it is not displayed on the screen.
(Example)
• Entering AM 530 kHz: Press [5], [3], and [0] keys in order.
• Entering AM 1620 kHz: Press [1], [6], [2], and [0] keys in order.
• Entering FM 87.9 MHz: Press [8], [7], and [9] keys in order.
• Entering FM 107.9 MHz: Press [1], [0], [7], and [9] keys in order.
Notes
• The frequency indication stops flashing when the receiving frequency entry is completed, indicating
termination of Direct tuning mode.
• When 5 seconds has passed without key entry for receiving frequency, the Direct tuning mode is
automatically terminated and the unit reverts to the former status.