Rack mounting – Toa DT-930 UL User Manual
Page 11
11
DT-930
Note
The rack mounting screws (5 x 12) are dedicated for the TOA equipment racks.
Do not use them for other racks.
Rack mounting screw 5 x 12
(supplied with the MB-15B)
Fiber washer for M5
(supplied with the MB-15B)
Tapping screw 3 x 14
(supplied with the MB-15B)
MB-15B (optional)
10. RACK MOUNTING
When mounting the unit on an equipment rack, use the optional Rack Mounting Bracket MB-15B.
Before mounting, remove 4 plastic feet on the unit bottom.
Note
Be sure to place the unit below heat generating equipment such as power supply units or amplifiers. Put a
perforated panel between the unit and the heat generating equipment as required.
See also other documents in the category Toa Equipment:
- D-2000 Series Installation (84 pages)
- DD-2000 Series Manual (24 pages)
- D-2000 Series Read Me First (12 pages)
- D-2012AS (2 pages)
- D-2012C (4 pages)
- D-901 (96 pages)
- CR-273 (20 pages)
- CR-413-6 (20 pages)
- EV-20R (20 pages)
- MP-1216 (8 pages)
- MB-WT3 (2 pages)
- MT-251H (1 page)
- F-2322C (12 pages)
- F-2852C (12 pages)
- SC-630 (2 pages)
- ES-0851 (4 pages)
- ES-C0651 (4 pages)
- F-1000B (18 pages)
- F-122C (12 pages)
- F-122CU (20 pages)
- F-122CU2 (16 pages)
- F-1300B (18 pages)
- F-1522SC (8 pages)
- AN-9001 (1 page)
- C-AL80 (16 pages)
- DP-K1 (28 pages)
- DP-K1 (102 pages)
- DP-L2 v.2.00 (28 pages)
- DP-SP3 Protocol (14 pages)
- DP-SP3 (24 pages)
- DP-SP3 (75 pages)
- E-232 (8 pages)
- AT-063AP (4 pages)
- BS-1015BSB (8 pages)
- BS-1030B (4 pages)
- BS-634 (4 pages)
- BS-1034EN (8 pages)
- BS-1110W (4 pages)
- BS-301B (8 pages)
- BS-301B AS (4 pages)
- MB-WT1 (1 page)
- S-D7300 (16 pages)
- VX-200SP-2 (24 pages)
- YA-1000A (1 page)
- ZM-9001 (2 pages)