Tie Down ABS Stabilizer Plate User Manual
Abs stabilizer plate installation instructions

0
51
6
0
2,
31
5
ABS Stabilizer Plate Installation Instructions
Part #59293
1. Determine correct anchor to be used with the home installation and use the manufacturer instruction for
installation, following all safety precautions.
2. Using an electric drive machine, install anchor to a depth of approximately 28 inches at a slight
back angle.
3. Dig out an 8" wide area so that the ABS stabilizer will be placed on undisturbed soil at a 10 to 15 degree
angle toward the home. The bottom center of the plate should be touching the anchor rod.
4. Complete the installation of the ground anchor until the bottom of the anchor head is flush
with the ground.
5. Attach proper strap and tension strap until anchor head is flush against the ABS plate and strap is tight.
At this point, soil should be tamped into the vacant area behind the anchor rod, tamping approximately 6"
and repeating until the vacant area is flush with the surface of the surrounding ground.
1.
2.
4.
3.
Place ABS
Plate Here
Tamp Soil
In 6" increments
- 660E (16 pages)
- 750E (16 pages)
- LP750 (16 pages)
- 850E (16 pages)
- Drum Brakes (12 pages)
- Torsion Axle (4 pages)
- Eliminator Vented Disc Brakes (12 pages)
- G5 (12 pages)
- Super Lube Hubs (4 pages)
- Vortex Hubs for Spindles (4 pages)
- 66 Actuator (8 pages)
- 70 Actuator (1 page)
- 66 Actuator For Serial #16020 and above (8 pages)
- 66 Weld-On Actuators (2 pages)
- 70 Brake Actuator (8 pages)
- 70E (8 pages)
- 70LP (8 pages)
- 75LP (8 pages)
- LP850 (16 pages)
- 85 Actuator (8 pages)
- 80 Actuator (8 pages)
- 80LP (8 pages)
- 125 Alien Actuator (8 pages)
- 125 Actuator (8 pages)
- 145 Raptor Actuator (8 pages)
- 165 Raptor Actuator (8 pages)
- LP16.5 (8 pages)
- 20 Raptor Actuator (8 pages)
- Back Flow Style Brake Solenoid (1 page)
- Brake Line Kit for "Add On Axles" (2 pages)
- Brake Line Kit for Single Axles (2 pages)
- Brake Line Kit for Tandem Axles (2 pages)
- Brake Solenoid Kit for use with Tie Down's Brake Actuator (1 page)
- Drum Brake Kit for Electric Brakes (4 pages)
- Drum Brake Kit (4 pages)
- Replacement Brake Shoes (4 pages)
- Trailer Brake Flush Kit (1 page)
- TSB - Drum Brakes (2 pages)
- Vortex Hub (2 pages)
- Wheel Hub Kit (1 page)
- Dust Cap (1 page)
- Replacing End Units on Eliminator Torsion axles (1 page)
- Turbo Lube Replacement O-Ring (1 page)
- Turbo Lube (8 pages)
- Spindles Procedure for Removing and Replacing Spindle Wear Sleeves (2 pages)