Releasing the emergency stop – Tie Down 125 Actuator User Manual
Page 8
TIE DOWN ENGINEERING • 255 Villanova Drive SW • Atlanta, GA 30336
www.tiedown.com (404) 344-0000 Fax (404) 349-0401
WARNING:
If the emergency stop bracket is towards the rear (shown in #2) , this indicates that the
emergency stop bracket is “set” and must be released before using the trailer.
Photo 1
Photo 2
Photo 3
Releasing The Emergency Stop
Emergency Brake Disengaged
- Normal Use -
Emergency Brake Engaged
- DO NOT TOW -
Emergency Stop Release Bracket
-Pry up to release Emergency stop-
To Release the Emergency Brake:
Pry up the emergency stop release bracket (located on the
underside of the actuator) with a screwdriver (Photo 3) until
the E-stop bracket snaps back into the disengaged position
(Photo 1).
Note: if you any reason you believe your brakes are
engaged, the release procedure can be preformed at any
time. Always make sure the release bracket is towards the
tow vehicle (Photo 1).
- 660E (16 pages)
- 750E (16 pages)
- LP750 (16 pages)
- 850E (16 pages)
- Drum Brakes (12 pages)
- Torsion Axle (4 pages)
- Eliminator Vented Disc Brakes (12 pages)
- G5 (12 pages)
- Super Lube Hubs (4 pages)
- Vortex Hubs for Spindles (4 pages)
- 66 Actuator (8 pages)
- 70 Actuator (1 page)
- 66 Actuator For Serial #16020 and above (8 pages)
- 66 Weld-On Actuators (2 pages)
- 70 Brake Actuator (8 pages)
- 70E (8 pages)
- 70LP (8 pages)
- 75LP (8 pages)
- LP850 (16 pages)
- 85 Actuator (8 pages)
- 80 Actuator (8 pages)
- 80LP (8 pages)
- 125 Alien Actuator (8 pages)
- 145 Raptor Actuator (8 pages)
- 165 Raptor Actuator (8 pages)
- LP16.5 (8 pages)
- 20 Raptor Actuator (8 pages)
- Back Flow Style Brake Solenoid (1 page)
- Brake Line Kit for "Add On Axles" (2 pages)
- Brake Line Kit for Single Axles (2 pages)
- Brake Line Kit for Tandem Axles (2 pages)
- Brake Solenoid Kit for use with Tie Down's Brake Actuator (1 page)
- Drum Brake Kit for Electric Brakes (4 pages)
- Drum Brake Kit (4 pages)
- Replacement Brake Shoes (4 pages)
- Trailer Brake Flush Kit (1 page)
- TSB - Drum Brakes (2 pages)
- Vortex Hub (2 pages)
- Wheel Hub Kit (1 page)
- Dust Cap (1 page)
- Replacing End Units on Eliminator Torsion axles (1 page)
- Turbo Lube Replacement O-Ring (1 page)
- Turbo Lube (8 pages)
- Spindles Procedure for Removing and Replacing Spindle Wear Sleeves (2 pages)