TeeJet FieldPilot Install Ford Versatile 8x6-9x6 - Manual (Page 18)

www.teejet.com
16
FieldPilot ®
12. recOMMended electrOnics installatiOn
The Steering Control Module (SCM) should be mounted securely to the floor of the cab as far forward in the
cab as possible. The control console can be mounted to the operator’s preference. The GPS antenna should
be mounted as far forward as possible on top of the hood on a metal surface of at least 4” square.
The Articulated Gyro Module (AGM) should be mounted towards the rear of the vehicle on a flat surface that
is horizontal to the ground. Plug the CAN extension cable to the AGM Harness (45-07716) as well as the
CAN terminator. Route the other end of the CAN extension cable towards the cab and connect to the CAN on
the SCM harness.
Figure 1-14: Recommended Electronics Installation
sCM
Console
Gps
AGM