TeeJet FieldPilot Install Ford NH 8x70 - Manual (Page 16)

www.teejet.com
14
FieldPilot ®
9. install leFt and right steer hoses
The steering hoses will connect to run tees installed at the front steering cylinder. Disconnect the left side
hose from the inline Tee. Attach the run of the new (U) Tee to the branch of the existing Tee. Reconnect
the existing hose to the run of the (U) Tee. Connect the (P) 90° hose end to the branch of the (U) Tee.
Connect the straight hose end to port A on the FieldPilot valve. Disconnect the right side hose from the
inline Tee. Attach the run of the new (U) Tee to the branch of the existing Tee. Reconnect the existing hose
to the run of the (U) Tee. Connect the (Q) 90° hose end to the branch of the (U) Tee. Connect the straight
hose end to port B on the FieldPilot valve.
Figure 1-10: Install Left and Right Steer Hoses
U
U
P
Q
10. install the ValVe control caBle
Connect the FieldPilot valve control cable (E) to the coils on the FieldPilot valve and route the cable into the
cab. Connect it to the SCM harness. Do not be concerned at this time about which connector is connected to
which solenoid coil.