TC-Helicon HarmonyControl Guitar - Manual (Page 6)

7 77
Step 1:
Set up your harmony processor, microphone and PA
system as you would normally. If this is the first setup
with the harmony processor, consult its manual for
proper setup.
Harmony
Processor
Step 2:
Connect a cable from your guitar to the Guitar In jack
on HarmonyControl. Then connect a cable from the
Guitar Out jack on HarmonyControl to your amplifier
or a channel in your PA system. HarmonyControl
should be the first link in any effects chain. Any guitar
processing done before the guitar signal is fed to
HarmonyControl will reduce accuracy.
4
MIDI GUITAR
IN OUT IN OUT
To amp
or PA
Quick Start