TC-Helicon VoiceOne Manual - Manual (Page 17)

15
PRESET HANDLING
• Press STORE.
At this point you may edit the preset name.
To alter the preset name; use the ARROW
keys to move cursor between the character
positions, and the DATA wheel to select
character.
• Press STORE to store the preset with the
new name. If you choose not to alter the
preset name, simply press STORE without
altering the characters. This completes the
Store operation.
Backup Presets Via MIDI
The User bank can be dumped for backup via
MIDI to either a sequencer or another
VoiceOne. This is how to do it::
• Connect VoiceOne MIDI Out to MIDI In on
either another VoiceOne or sequencer.
• Enter the Utility menu by pressing the
MIDI/UTIL key and scroll to select Bulk
Dump using the ARROW KEYS.
• If connected to another VoiceOne simply
press ENTER and the entire User bank will
be copied to the other VoiceOne.
• If connected to a sequencer let the
sequencer record in OMNI mode (all
channels) and press ENTER on the
VoiceOne.
The VoiceOne is always ready to receive a
MIDI System Exclusive Bulk Dump.
Simply connect MIDI Out from the device you
are dumping from (or another VoiceOne) to the
MIDI In on the VoiceOne. Send the bulk dump.
This sends out the User preset bank. If you are
dumping from a sequencer, simply play the
sequence holding the bulk sysex material you
previously recorded from a VoiceOne sysex
dump. Be sure you play back the sequence at
the same tempo or slower than the tempo that
the sequence was recorded at. You will need to
press the RECALL key to load a preset from a
bank dumped into the unit.
Preset types
Factory presets
The VoiceOne holds 100 factory presets.
Factory presets can be edited and stored in any
User location. You cannot store presets into a
factory location.
User presets
User presets can be edited and stored in any
User location. You can store up to 50 user
presets in the User bank.
Recall
Recalling a preset means loading/activating a
preset.
• Press RECALL to enter the RECALL menu.
• Use the DATA wheel to preview presets.
Blinking front panel lights indicate preview
mode. Previewing means that you are not
actually changing/loading the preset until
ENTER is pushed.
• Press ENTER or RECALL to recall/activate
the preset.
• Press any other key at any time during
previewing to return to the currently recalled
preset.
Edit
To edit preset parameters:
• Double click on the Pitch or VM key you
would like to edit,
• Select parameters using the ARROW KEYS
and change values using the DATA wheel.
• See the following section for instructions on
how to store a preset.
Store
To store a preset with the same name:
• Press STORE.
If the preset you are about to store is a
Factory preset the VoiceOne suggests the
first available User location, but you can
select any of the 50 locations using the DATA
wheel.
If the preset you are about to store is a User
preset, the VoiceOne remains on the current
location of the preset.
You can, however, store at any of the 50
User locations. Select location using the
DATA wheel.