TC-Helicon Play Electric - Reference Manual User Manual
Page 50
Vocal FX button/section
Play Electric – Reference manual (2014-07-16) 48
Transducer Advanced page
To enter the Advanced Transducer page, press
and hold any of the lit blue LED soft buttons.
Routing parameter
Use the Routing parameter to define which
signal components should be affected by the
Transducer effect.
Output setting
With the Output setting, the effect is applied to
the lead voice and any voices derived from it, like
Harmony or Doubling.
FX setting
With the FX setting, the effect is only applied to
voices within an effect. For example, if you are
using a delay, no effect will be applied to the ini-
tial “tap” of the delay, but subsequent “taps” will
have the Transducer effect applied.
Gate Threshold parameter
Transducer effects are very prone to feedback
via a PA or monitor. The Transducer block has
an independent gate that can be set to help al-
leviate feedback.
Raising the threshold will cause the effect to
“kick in” at a higher input volume, which can help
avoid feedback while you are not singing.
For more information about feedback and tips
on how to reduce or eliminate it, check out this
video:
Gain parameter
Use the Gain parameter to control the overall
level of the transducer effect.