TC-Helicon VoiceTone C1 Manual - Manual (Page 7)

First Setup and Use
1. Turn down your PA’s master volume.
2. Connect your mic and PA as shown in the diagram first, then plug in the AC adaptor. For live
performance, a USB connection to a computer is not required.
3. Set the key to C, Attack control to Hard and the Gender control to the center notch.
Optional - Connect an instrument as shown to guide correction and override the Key selector.
4. Sing into your mic while adjusting the MIC GAIN control so that the input level LED flashes green.
Brief flashes of red on the LED on your loudest singing are ok.
5. Ensure that the effect is on (center LED is lit).
6. Sing while turning up your PA volume to a comfortable level.
As you sing, you will hear your voice jumping from pitch to pitch in the key of C major. Play an
instrument or accompaniment in the same key to hear the HardTune effect in context. Now you can
experiment with the controls before reading the Effect Descriptions section below.
Phantom Power
There is no switch to enable phantom power on the VoiceTone singles. Phantom power is available
when the product is powered. Microphones that don’t require phantom power will operate properly.
Always apply power as the last connection step and ensure your PA is muted. This will reduce the
chance of audio pops that could harm your equipment.