beautypg.com

Installation of trim switch for rn/rp gas valves, Adjustment of levelling bar (if required), Venting and installation – Vermont Casting RHEDV25 User Manual

Page 7

background image

7

10000801

Vermont Castings, Majestic Products RHEDV Direct Vent Insert

Installation of Trim Switch

for RN/RP Gas Valves

1. Thread wire through openings on the right side of

fireplace. Do not cut wire or insulation on metal edges.

2. Slide switch assembly from the back, between subframe

and trim, then fasten the screw. (Fig. 5)

3. For left side installation reverse switch position in

bracket and repeat Step 2. (Fig. 6)

4. Connect wiring to gas valve (Fig. 7a & b) and switch.

CAUTION: Do not wire millivolt remote
wall switch for gas fireplace to a 120v
power supply.

Adjustment of Levelling Bar

(If Required)

1. Determine height of adjustment.

2. Loosen the four (4) screws. (Fig. 8)

3. Set bar at proper height and tighten the screws.

4. Add the two (2) extra screws to prevent any movement.

Venting and Installation

1. The Majestic fireplace may be installed in and

vented through any solid fuel fireplace that has a
minimum fireplace opening 28

³⁄₄

" wide x 21

¹⁄₄

" high x

16" deep and has been installed in accordance with
the National, Provincial/State and local building
codes and is constructed of noncombustible
materials.

2. Only HEDVT (8 x 12) or HEDVT (12 x 12)

termination kit and flex vent kit HEDVK25 or
HEDVK35 is able to be used in this installation.
Under no circumstances should B vent or C vent
be used on this application.

3. Any flue damper must be removed or blocked open.

Trim Top

Left Side Installation

Right Side Installation

Trim Right
Side

Trim
Screw

On/Off Switch
Assembly

Wiring from
Millivolt Gas
Valve

Trim
Screw

Trim Left
Side

On/Off Switch Assembly

FP1253

Fig. 5 Slide switch assembly between subframe and trim.

Bracket Switch

On/Off
Switch

FP1254

Fig. 6 For left side installation, reverse switch position in
bracket.

PILO

T

THTP

TP

TH

SIT Valve

Thermopile

FP382a

Fig. 7a On/Off switch or millivolt thermostat.

TPTH

TH

TP

FP1218

Fig. 7b On/Off switch wiring.

Back of Unit

Levelling Bar

Set Screws

FP1279

Fig. 8 Set levelling bar at proper height and tighten screws.