Vermont Casting RHEDV25 - Manual (Page 29)

29 10000801
Vermont Castings, Majestic Products RHEDV Direct Vent Insert
B2 RHEBSL & RHEBXL Trims
For use with RHEDV32
Trim Assembly
RHEBSL
1. Install trim channels (left and right sides). Use two
screws to assemble each piece.
2. Slide on the trim top channel and fasten it from the
back side.
3. Install the trim top deflector and use two screws to
fasten it. (Fig. 42)
4. Remove ALL plastic protective covering from brass
trim.
Trim Top Deflector
Trim Frame Top
Section
Side View
FP1261a
Fig. 42 Trim top deflector.
RHEBXL
To install the kit you do not have to remove any
piece of brass, you just add the external pieces.
Remove the frame trim from the unit if it is already
installed.
1. Install trim channels (left and right sides)by removing
the two screws that hold the side brass trim and put
them back to hold both parts.
2. Slide on the trim top channel and fasten it from the
back side.
3. Remove the two screws that hold the top brass trim.
4. Install the two brackets to the studs in the bottom of
the top channel. Use the nuts supplied with the kit.
5. Reinstall the two screws to hold the top trim channel.
Key Description RHEBSLP RHEBSLA RHEBXLP (1) RHEBXLA (1)
1 Trim Frame Flat Black 57926 57926 - -
2 Trim Top Deflector 17634-PB 17634-AB - -
3 Trim Top Channel 57864 57844 - -
4 Trim Side Channel 57862 57843 - -
5 Trim Outer Top Channel - - 57861 57845
6 Trim Outer Side Channel - - 57863 57846
7 Fasteners Package (Not Shown) 54618 54618 57633 57633
5
3
6 4 6 4
1
2
IMPORTANT: Only Trim Panel Assemblies Approved by
Vermont Castings, Majestic Products Can Be Used on
These Products.
ALL repair parts will be available from your local dealer.
When ordering, always give the following information:
Model and serial number, part description with finish and
part number;
Vermont Castings, Majestic Products reserves the right to make changes in design, materials, specifications, prices and discontinue colors and
products at any time, without notice.
(1) RHEBXLP or RHEBXLA to be used with RHEBSLP
or RHEBSLA trims.
(2) SL trim dimensions are for openings smaller than
27
¹⁄₂
"H x 40
¹⁄₂
" W (700mm x 1030mm)
(4) XL trim dimensions are for openings smaller than
30"H x 45 ⁵⁄₈ " W (765mm x 1160mm)
RHEBSLP, RHEBSLA, RHEBXLP, RHEBXLA Trim Replacement Parts